Oak Grove Heating and Air
Oak Grove Heating and Air Home HVAC Oak Grove Heating and Air About Us Heating and Cooling Oak Grove Heating and Air Air Quality Oak Grove Heating and Air Services Residential Air Conditioning Oak Grove Products Commercial Air Conditioning Oak Grove Heating and Air Contact Us

We Provide The Service Plan Your Equipment Needs

PLAN A
(Gas Furnace)

PLAN B
(Air Conditioner)
  1. Clean and adjust automatic controls.
  2. Clean burners.
  3. Adjust combustion for optimum fuel efficiency.
  4. Lubricate as needed.
  5. Test for combustion leaks.
  6. Test safety shutoff response.
  7. Check blower belt wear, tension and alignment.
  8. Check flue for satisfactory operation.
  9. Change filter at each visit.
  1. Clean condenser coil if necessary.
  2. Check electrical connections for tightness.
  3. Adjust system for optimum cooling.
  4. Check for oil and refrigerant leaks.
  5. Check safety devices.
  6. Check blower belt wear, tension and alignment.
  7. Check expansion valve and coil temperatures.
  8. Check refrigerant level.
  9. Check condensate drain.
  10. Lubricate as needed.

PLAN C
(Heat Pump)

PLAN D
(Electric Furnace)
  1. Lubricate as needed.
  2. Check defrost cycle and reversing valve operation.
  3. Adjust air volume for maximum efficiency.
  4. Check safety devices and electrical connections for tightness.
  5. Check blower belt wear, tension and alignment.
  6. Check for oil and refrigerant leaks.
  7. Test electrical controls for proper operation.
  8. Check refrigerant level.
  9. Check refrigerant controls and coil temperature for maximum efficiency.
  10. Check condensate drain.
  1. Clean and check automatic controls.
  2. Check all wiring for loose connections and condition of insulation.
  3. Check supply voltage.
  4. Check amperage draw.
  5. Lubricate as needed.
  6. Test safety shut-off response.
  7. Check blower belt wear, tension and alignment.

 

Conditions:

We agree to:

  1. Inspect the equipment on a scheduled basis as shown, and during each inspection perform the applicable services per above checklist.
  2. Instruct you in the operation of the equipment.
  3. Give our service contract holders preference over all other service activity normally undertaken by us.

You agree to:

  1. Operate the equipment according to our instructions.
  2. Promptly notify us of any unusual operating conditions of the equipment.
  3. Permit our personnel the use of your common building maintenance tools, such as ladders, etc.
  4. Permit only our service personnel and/or a service organization authorized by us to work on the equipment

General:
During the term of the agreement we will take all reasonable precautions to avoid injury to persons and damage to property while on the premises, but we shall not be liable for any special or consequential damages.

We shall not be liable for losses or defect arising out of vandalism, fire, flood, wind, war, riots and acts of God. In such cases, the customer shall be charged for the parts and labor involved at the then current price for such repairs. No such parts or labor shall be furnished, however, without authorization form the customer.

 

 

IF YOUR HEATING OR AIR CONDITIONING SYSTEM FAILS TO OPERATE:
  1. Be sure thermostat is set on “Heat” or “Cool” as needed, and set properly.
  2. Check all switches, fuses, and circuit breakers to be sure there is electricity to the unit.
  3. Check filters to be sure they are not clogged.
  4. Be sure the gas is on.
Powered By MegaGate Broadband - 2008 All Rights Reserved